Is-Is Configuration Task List - HP 6125XLG Configuration Manual

RFC 2966, Domain-wide Prefix Distribution with Two-Level IS-IS
•
• RFC 2973, IS-IS Mesh Groups
RFC 3277, IS-IS Transient Blackhole Avoidance
•
RFC 3358, Optional Checksums in ISIS
•
• RFC 3373, Three-Way Handshake for IS-IS Point-to-Point Adjacencies
RFC 3567, Intermediate System to Intermediate System (IS-IS) Cryptographic Authentication
•
RFC 3719, Recommendations for Interoperable Networks using IS-IS
•
RFC 3786, Extending the Number of IS-IS LSP Fragments Beyond the 256 Limit
•
RFC 3787, Recommendations for Interoperable IP Networks using IS-IS
•
• RFC 3847, Restart Signaling for IS-IS

IS-IS configuration task list

Tasks at a glance
Configuring basic
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
•
Configuring IS-IS link cost
•
Specifying a preference for IS-IS
•
Configuring the maximum number of ECMP routes
•
Configuring IS-IS route summarization
•
Advertising a default route
•
Configuring IS-IS route redistribution
•
Configuring IS-IS route filtering
•
Configuring IS-IS route leaking
(Optional.)
•
Specifying intervals for sending IS-IS hello and CSNP packets
•
Specifying the IS-IS hello multiplier
•
Configuring a DIS priority for an interface
•
Disabling an interface from sending/receiving IS-IS packets
•
Enabling an interface to send small hello packets
•
Configuring LSP parameters
•
Controlling SPF calculation interval
•
Configuring convergence priorities for specific routes
•
Setting the LSDB overload bit
•
Configuring system ID to host name mappings
•
Enabling the logging of neighbor state changes
•
Enabling IS-IS ISPF
IS-IS:
Enabling IS-IS
Configuring the IS level and circuit level
Configuring P2P network type for an interface
Configuring IS-IS route control:
Tuning and optimizing IS-IS networks:
115