Ipv6 Bgp Configuration Examples; Ipv6 Bgp Basic Configuration Example - HP 6125XLG Configuration Manual

BGP.: 3.0.1.1 Send NOTIFICATION
Err/SubErr: 6/0 (Cease/ErrSubCode Unspecified)
Error data NULL.
*Mar 12 19:02:59:243 2012 SwitchC BGP/7/DEBUG: -VDC=1;
BGP.: 3.0.1.1 State is changed from ESTABLISHED to IDLE.
The output shows that Switch C can quickly detect the link failure and notify BGP to change the
relevant IBGP session state.
# Display route 1.1.1.0/24 on Switch C.
<SwitchC> display ip routing-table 1.1.1.0 24 verbose
Summary Count : 1
Destination: 1.1.1.0/24
Protocol: BGP
SubProtID: 0x1
OrigTblID: 0x1
TableID: 0x2
AttrID: 0x0
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid
The output shows that Switch C communicates with network 1.1.1.0/24 through the path Switch
C<—>Switch D<—>Switch A.

IPv6 BGP configuration examples

IPv6 BGP basic configuration example

Network requirements
In Figure 67, run EBGP between Switch A and Switch B, and run IBGP between Switch B and Switch C
so that Switch C can access the network 50::/64 connected to Switch A.
Figure 67 Network diagram
Cost: 100
Tag: 0
NBRID: 0x15000000
Flags: 0x10060
Label: NULL
Process ID: 0
Age: 00h03m08s
Preference: 255
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 2.0.1.1
OrigNextHop: 2.0.1.1
RealNextHop: 2.0.2.1
BkNextHop: N/A
Interface: Vlan-interface201
BkInterface: N/A
257