Configuring Ripng Route Redistribution; Tuning And Optimizing The Ripng Network; Configuring Ripng Timers - HP 6125XLG Configuration Manual

To configure a preference for RIPng:
Step
1. Enter system view.
2. Enter RIPng view.
3. Configure a preference for
RIPng.

Configuring RIPng route redistribution

Step
1. Enter system view.
2. Enter RIPng view.
3. Redistribute routes from other
routing protocols.
4. (Optional.) Configure a
default routing metric for
redistributed routes.

Tuning and optimizing the RIPng network

This section describes how to tune and optimize the performance of the RIPng network as well as
applications under special network environments.
Before you tune and optimize the RIPng network, complete the following tasks:
Configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring nodes.
•
Configure basic RIPng.
•

Configuring RIPng timers

You can adjust RIPng timers to optimize the performance of the RIPng network.
When you adjust RIPng timers, consider the network performance, and perform unified configurations on
routers running RIPng to avoid unnecessary network traffic or route oscillation.
To configure RIPng timers:
Step
1. Enter system view.
2. Enter RIPng view.
Command
system-view
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
preference [ route-policy
route-policy-name ] value
Command
system-view
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
default cost cost
Command
system-view
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
290
Remarks
N/A
N/A
The default setting is 100.
Remarks
N/A
N/A
By default, RIPng does not
redistribute routes from other
routing protocols.
The default metric of redistributed
routes is 0.
Remarks
N/A
N/A