Calling Up Registration Memory Numbers In Order (Registration Sequence) - Yamaha Tyros5 Reference Manual

Calling Up Registration Memory Numbers in Order (Registration
Sequence)
As convenient as the Registration Memory buttons are, there may be times during a performance when you want to
even more easily switch between settings. The convenient Registration Sequence function lets you call up the eight
setups in any order you specify, by simply using the TAB [E][F] buttons (in the Main display) or the pedal as you
play.
1
If you intend to use a pedal or pedals to switch the Registration Memory number, con-
nect the optional pedals to the appropriate FOOT PEDAL jacks.
For instructions, refer to Chapter 11 of the Owner's Manual.
2
In the REGISTRATION BANK display, select the desired Bank to be programmed.
3
Call up the operation display.
[FUNCTION]  [E] REGIST SEQUENCE/FREEZE/VOICE SET  TAB [E][F] REGISTRATION
SEQUENCE
4
If you use a pedal, specify here how the pedal will be used—to advance or to reverse
through the sequence.
Use the [C] or [D] button to select the pedal for advancing or reversing through the Registration Sequence. For
example, if two pedals are connected, Pedal 1 is used for advancing while Pedal 2 is used for reversing. Note that
the pedal settings here (other than OFF) will take priority over the settings in the FOOT PEDAL display
(page 133). If you want to use the pedal for a function other than Registration Sequence, make sure to set this to
OFF.
4
6
5
Program the Sequence order, from left to right.
Press one of the REGISTRATION MEMORY [1]–[8] buttons on the panel, then press the [6 ] (INSERT) but-
ton to input the number.
NEXT PAGE
Indicates the name of the currently selected
Registration Memory Bank.
7
Indicates the Registration Memory
numbers, in the order of the current
Registration Sequence.
Tyros5 Reference Manual
7
97