Vocal Page - Yamaha Tyros5 Reference Manual

VOCAL Page

3-BAND EQ (selected by [A]/[B] buttons)
EQ (Equalizer) is a processor that divides the frequency spectrum into multiple bands which can be boosted or cut
as required to tailor the overall frequency response. This instrument features a high-grade three-band (LOW, MID
and HIGH) digital equalizer function for the microphone sound.
[1 ]/
[3 ]/
[5 ]
[2 ]/
[4 ]/
[6 ]
NOISE GATE (selected by [C]/[D] buttons)
This effect mutes the input signal when the input from the microphone falls below a specified level. This effec-
tively cuts off extraneous noise, allowing the desired signal (vocal, etc.) to pass.
[1 ]
[2 ]
COMPRESSOR (selected by [C]/[D] buttons)
This effect holds down the output when the input signal from the microphone exceeds a specified level. This is
especially useful for smoothing out vocals that have widely varying dynamics. It effectively "compresses" the sig-
nal, making soft parts louder and loud parts softer. For a maximum compression effect, set RATIO to a high setting
and adjust the OUT parameter for optimum volume.
[3 ]
[4 ]
[5 ]
[6 ]
PITCH DETECT (selected by [E] button)
Determines how this instrument detects or recognizes the pitch of the microphone sound you input during perfor-
mance.
[1 ]/
[2 ]
[3 ]/
[4 ]
[5 ]/
[6 ]
102 Tyros5 Reference Manual
Hz Adjusts the center frequency of the corresponding band.
dB Boosts or cuts the level of the corresponding band by up to 12 dB.
SW (Switch) Turns the Noise Gate on or off.
TH. (Threshold) Adjusts the input level at which the gate begins to open.
SW (Switch) Turns the Compressor on or off.
TH. (Threshold) Adjusts the input level above which the Compressor is applied.
RATIO Adjusts the compression ratio. Higher ratios result in a more compressed sound, with
a reduced dynamic range.
OUT Adjusts the final output level.
VOCAL TYPE Set this to obtain the most natural vocal harmony, depending on your voice.
LOW: Setting for lower voices. This setting is also appropriate for growling and
shouting.
MID: Setting for mid-range voices.
HIGH: Setting for higher voices. This setting is also appropriate for singing close to
the microphone.
FULL: Setting for vocalists having a wide range, from low to high.
BACKGROUND THRU, 200Hz, 300Hz, 400Hz, 500Hz: This allows you to filter out low noises that
NOISE CUT would interfere with the Vocal Harmony effect. A setting of "THRU" turns the
noise filter off.
SPEED 1 (SLOW) – 4 (NORMAL) – 15 (FAST): Adjusts the response of the Vocal Har-
mony effect, or how quickly harmonies are generated in response to your voice.
NOTE
When the Vocal Harmony's Pitch Detect Speed of one or both parts of Lead and Harm. are set to "as Mic
Setting" in the Detail tab
Harmony's Pitch Detect Speed is effective.
(page 110), this parameter is effective. In other settings, the setting of the Vocal