Mfc10 Settings - Yamaha Tyros5 Reference Manual

MFC10 Settings

The explanations here apply to the MFC10 Page in step 4 on
By connecting an optional MFC10 MIDI Foot Controller to the Tyros5, you can conveniently control a wide range of
operations and functions by using your feet—perfect for changing settings and controlling the sound while you perform
live. Different functions can be assigned to each of the footswitches and up to five foot controllers (optional) can be con-
nected to the MFC10, for additional sound-shaping possibilities.
1
Connect the MIDI IN terminal of the MFC10 to one of the MIDI OUT terminals of the
Tyros5 by using a MIDI cable.
2
Set the MFC10 to the normal mode and turn the [FUNCTION] lamp of the MFC10 on.
3
Perform steps 1–4 on
4
Set the parameters on this display as desired.
4-1
On this display, two settings (below) can be made:
• Each footswitch (F00–F29) on the MFC10 sends a note number to the Tyros5, and the Tyros5 determines how it
responds to (which function is executed by) that note number.
• Each foot controller on the MFC10 sends control change messages over a specific control change number to the
Tyros5, and the Tyros5 determines how it responds to (which parameter is changed by) that control change num-
ber.
4-1
Use the [A]/[E] buttons to select "FOOTSWITCH" or "FOOT CONTROLLER."
4-2 Use the [2 ]/[3 ] buttons to select a footswitch number (F00–F29) or a foot controller number (1–
5) to which the function is assigned.
Please note that a note number is assigned to each footswitch and a control change number is assigned to
each foot controller beforehand and the settings cannot be changed.
NEXT PAGE
142 Tyros5 Reference Manual
MFC10
MIDI IN
If desired, connect
additional foot control-
lers to the MFC10.
page 136 to call up the MFC10 Page.
4-2 4-3
page 136.
MIDI OUT
4-5
4-6
5
4-4