Normalize; Adjusting The Volume Balance; Deleting A Track - Yamaha Tyros5 Reference Manual

(1) Normalize

Normalize raises the volume of the recorded audio to the optimum level. Use this to make the recorded audio as loud as
possible, without distortion. Technically, this operation scans the recorded file for the highest level, then raises the vol-
ume of the entire file so that the highest peak is set to the maximum, non-distorting level. Normalization is calculated for
the loudest signal found in either channel of the stereo recording and the same gain is applied to both channels.
1
Press the [F] (TRACK SELECT) button to select the track to be normalized.
2
Press the [I] (NORMALIZE) button.
3
At the prompt, press the [G] (OK) button to start normalizing the selected track.
To cancel the operation, press the [H] (CANCEL) button.

(2) Adjusting the Volume Balance

On the TRACK PLAY meter, you can adjust the volume of Main and Sub tracks sepa-
rately. Use the [4 ]/[6 ] buttons or sliders to adjust the Main/Sub track volume.
By using the [3 ]/[5 ] buttons, you can also mute the Main/Sub tracks.

(3) Deleting a Track

1
Press the [F] (TRACK SELECT) button to select the track to be deleted.
2
Press the [H] (TRACK DELETE) button.
3
At the prompt, press the [G] (OK) button to start deleting the selected track.
To cancel the operation and leave the track intact, press the [G] (UNDO) button, before executing any other opera-
tion.
NOTE
To control overall volume of the audio
file, press the [BALANCE] button once
or twice to call up the BALANCE (2/2)
display, then use the [4 ] slider or
buttons.
Tyros5 Reference Manual
5
83