Removing And Installing The Server Cover; Removing The Server System Cover; Figure 11. Removing The Server System Cover - Intel SR1695GPRX Service Manual

Removing and Installing the Server Cover

Removing the Server System Cover

You must operate the server system with the system cover in place to ensure proper
cooling. You must remove the top cover to add or replace components inside of the server.
None of the internal components are hot-swappable. Before you remove the server system
cover, power down the server and unplug all peripheral devices and the power cable.
Note: You may need a non-skid surface or a stop behind the server system to prevent the server
system from sliding on your work surface.
1. Remove the top cover screw (see letter "A").
2. Loosen the screw at the rear of the chassis (see letter "B").
3. Push rearward on the blue grip point at the front of the server.
4. Slide the cover back until it stops and then lift the cover upward to remove it. See
letter "C".
28
A

Figure 11. Removing the Server System Cover

B
C
®
Intel Server System SR1695GPRX Service Guide
EP0004