Installing And Removing A Hot-Swap Hard Drive; Installing A Sas Or Sata Hot-Swap Hard Disk Drive; Figure 22. Pulling Out The Back Lever - Intel SR1695GPRX Service Manual

6. Reinstall and reconnect any parts you removed or disconnected to reach the
processor sockets.
7. Install the server system cover. For instructions, see
Cover".

Installing and Removing a Hot-swap Hard Drive

You can install up to two fixed SATA drives in the Intel
See "Server System References"
Caution: If you install less than four drives or devices, the empty drive bays must be occupied by
carriers with drive blanks to maintain proper system cooling.
To avoid possible damage to your server system, use only the drive carriers that came
with your system.

Installing a SAS or SATA Hot-swap Hard Disk Drive

Note: The server system does not support all hard drives. See
link to a list of supported hardware.
1. Open the latch at the front of the hard drive carrier (see letter "A").
2. Pull out on the black lever and slide the carrier from the server system (see letter
"B").
3. Remove the hard drive from its wrapper and place it on an antistatic surface.
4. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
®
Intel Server System SR1695GPRX Service Guide
for a link to a list of supported hardware.
A

Figure 22. Pulling out the back lever

"Installing the Server System
®
Server System SR1695GPRX.
"Server System References"
B
for a
AF003302
39