Using a T-25 Torx driver, remove the upper and lower rear door lock catches by removing the two
4.
screws from each of the upper and lower rear door lock catches. Retain the door lock catches and
screws for reinstallation.
NOTE:
Installing the rear extension assembly
Install the side assemblies of the rear extension assembly.
1.
Align the right-side assembly with the rack frame (1).
a.
Hook the extension into the rack frame at the three hook locations at the top, middle, and bottom of
b.
the rack.
Using a T-25 Torx screwdriver, insert and tighten one M5.5 self-tapping screws into each of the
c.
three hook locations to secure the side assembly to the rack frame (2).
Install the solid rear rack doors after you have installed the AF028A kit.
Rack Air Duct kit 95