Table of Contents
Advertisement
Ground Bonding kit
About this device
The HP Ground Bonding kit reduces the electromagnetic emissions outside the rack. These emissions are
produced during normal operation of the electronic components within the rack. Typically, rack-mounted
equipment must meet class A emissions levels, but you might want to reduce these levels even further. Use this
kit to tie all the conductive structural components together with conductive cables, and then attach the kit to
a ground bonding point on the AC power distribution device of the rack or the building ground.
Kit contents
Item
15.24-cm (6-in) grounding straps
15.24-cm (6-in) grounding straps
(with a connector on one end)
36.83-cm (14.5-in) grounding straps 8
36.83-cm (14.5-in) grounding straps
(with a connector on one end)
M8 internal serrated lock washer
M8 hex nut
M5.5 T-25 Torx screw
M6 x 10-mm Torx screw
M8 x 20-mm bolt
M8 Belleville toothed washer
M5 Belleville toothed washer
This kit might contain extra hardware for your convenience.
Required tools
The following tools are required for installation:
•
T-25 Torx driver
•
M8 socket
Installing the ground bonding rack option kit on HP
10000 G2 Series Racks
Attach the appropriate grounding straps to the following locations:
From the system chassis to the front door (without a grounding lug):
Remove the rack front door.
1.
Quantity
6
6
6
20
20
12
1
1
1
1
Ground Bonding kit 49
Advertisement
Table of Contents
