Table of Contents
Advertisement
Remove the perforated top plate of the rack (2).
2.
Align the solid plate with the top of the rack (1).
3.
Using a T-30 Torx screwdriver, insert and tighten two of the four M-12 bolts (from step 1) into the two
4.
corner holes at the front of rack (2).
Installing the solid rack base plate
From the rear of the rack, insert the left side plate into the rack, and set the plate on the lip of the rack
1.
frame (1).
NOTE:
top hole or the side hole, depending on your space allotment.
Using a T-25 Torx screwdriver, insert and tighten one M5.5 self-tapping screw at the rear, left corner
2.
and one M5.5 self-tapping screw at the front, left corner to secure the left side plate to the rack frame
(2).
When you insert the sheet metal screws to secure the base plates, you can either use the
Rack Air Duct kit 90
Advertisement
Table of Contents
