Table of Contents
Advertisement
Operation of the front door after installing the automatic door
release kit
After you have installed the automatic door release kit to the front door of your rack, to avoid mishandling the
latch handle of your door, HP recommends that you follow these guidelines when opening your rack front
door.
Set your magnetic locks into the half lock position.
1.
Insert the key into the latch handle of your rack front door, and lock the latch handle.
2.
Use the fixed door handles above and below the latch handle to pull your rack front door open.
3.
Installing the rear automatic door release kit
Install the rear electromagnetic locks
1.
and bottom of the rear rack frame.
Install the rear strike plates
2.
rear rack frame.
Install the right and left rear door release springs
3.
Install the rear magnetic lock cable
4.
Installation is complete.
Removing the rear door lock rods
Insert a flat-head screwdriver between the lock rod mounting points at the handle and the plate that
1.
secures it behind the plate.
("Installing the rear electromagnetic
("Installing the rear strike
("Installing the rear door release
("Installing the rear magnetic lock
locks" on page 20) to the top
plates" on page 22) to the top and bottom of the
cable" on page 24).
Automatic Door Release Kit 19
springs" on page 23).
Advertisement
Table of Contents
