Side Mount; Installing The Cross-Over Bracket - HP 10000 G2 Series Installation Manual

Using a T-25 Torx driver, insert one M6 x 16-mm Torx screw to secure the cable management D-ring
3.
bracket to the rack (2).

Side mount

Align the cable management D-ring bracket with the screw hole in the desired location on the side of
1.
your rack (1).
Using a T-25 Torx driver, insert one M5.5 x10-mm Torx screw to secure the cable management D-ring
2.
bracket to the rack (2).

Installing the cross-over bracket

Align the cross-over bracket with the appropriate screw holes in the desired location across the back of
1.
the rack (1).
Cable Management Bracket kit 32