Table of Contents
Advertisement
Rear Extension kit
About this device
The HP Rear Extension kit enables you to add 200-mm (7.87-in) of depth to the rear of the HP 10000 Series
and HP 10000 G2 Series racks.
The HP Rear Extension kit only fits the 600-mm (23.62-inch) wide (42U and 47U) rack models.
Kit contents
Item
Rear extension assembly
•
Left side assembly
•
Right side assembly
•
Top assembly
•
Bottom assembly
M5.5 self tapping screw
M6 machine screw
Rear extension cord
Cable management bracket
This kit might contain extra hardware for your convenience.
Required tools
The following tools are required for installation:
•
T-25 Torx driver
•
T-30 Torx driver
Removing the rear doors
Open the hinge brackets by pulling up the top hinge pin and pulling down the bottom hinge pin (1).
1.
Quantity
1
8
8
3
6
Rear Extension kit 105
Advertisement
Table of Contents
