Table of Contents
Advertisement
Tie-Down kit
About this device
The HP 10000 G2 Series Rack Tie-down Kit enables you to secure HP 10000 G2 Series Racks to the floor.
This kit is for all 10000 G2 Series Racks except for Rack SKUs AF092A and AF094A.
A separate tie-down kit is used exclusively for the 1200 full frame racks. This separate kit is for Rack SKUs
AF092A and AF094A only.
Required tools
The following tools are required for installation:
•
Ratchet with sockets
•
Adjustable wrench
Kit contents
Item
Front tie-down bracket
Rear tie-down bracket
M8 x 20-mm bolt
M8 flat washer
M8 spring clip
This kit might contain extra hardware for your convenience.
Installing the tie-down kit
This procedure is for all 10000 G2 Series racks except for Rack SKUs AF092A and AF094A.
To install the tie-down kit:
Adjust the leveling feet on the rack so that the full weight of the rack rests on the leveling feet.
1.
Align the front tie-down with the holes on the front caster plate.
2.
Quantity
1
1
8
8
4
Tie-Down kit 119
Advertisement
Table of Contents
