Rack Installation - HP Model 745 - VME Workstation Installation

Mast Installation
Model 748 ONLY
Figure 1.

Rack Installation

Figure 2 for Model 748 Front Out.
Figure 3 for Model 745 Front or Back Out,
Model 748 Back Out.
You may want to remove the feet.
101.6 mm
EIA Standard rack mount for Model 745.
235.0 mm
EIA Standard rack mount for Model 748.
Figure 2: 748 Front Out, Rack Mount
465.5 mm
465.5 mm
1. Peel off the
trim piece.
2. Attach the
spacer and
flange with
flange screws.
3. Install the
system
in rack with
dress screws.
1. Attach the
flange and
spacer with
flange screws.
CAUTION:
Spacer must be
outside of flange
or screws will
bind internal
modules. Get
someone to
help hold the
system for
installing it in
the mast.
2. Install the
system in
the mast with
dress screws.
Figure 1: Mast Mount (748 only)
1. Remove any
existing screws
as needed.
2. Attach the
flange and
spacer with
flange screws.
CAUTION:
Spacer must be
outside of flange
or screws will
bind internal
modules. Get
someone to
help you hold
the system
for installing it
in the rack.
3. Install the
system in
the rack with
dress screws.
Figure 3: 745 Front/Back Out, 748 Back Out,
2
Middle holes on
side.
Rack Mount