Table of Contents
Advertisement
Ground Bonding kit
About this device
The Ground Bonding kit reduces the electromagnetic emissions outside of the HP Advanced Series Racks and
Enterprise Series Racks. These emissions are produced during normal operation of the electronic components
within the rack. Typically, rack-mounted equipment must meet class A emissions levels, but you might want to
reduce these levels even further. Use this kit to tie all the conductive structural components together with
conductive cables, and then attach the kit to a ground bonding point on the AC power distribution device of
the rack or the building ground.
Kit contents
Item
15.24-cm (6-in) grounding straps
36.83-cm (14.5-in) grounding straps 3
15.24-cm (6-in) grounding straps
(with a connector on one end)
36.83-cm (14.5-in) grounding straps
(with a connector on one end)
M8 nut
Internal serrated lock washer
M8 x 20 hex head screw
Self-tapping 5.5 x 10 screw
6.2 Paint cutter washer
8.4 Paint cutter washer
M6 x 10 low HD cap screw
This kit might contain extra hardware for your convenience.
Required tools
The following tools are required for installation:
•
T-25 Torx driver
•
M8 socket
Installing the ground bonding rack option kit
Attach the appropriate grounding straps to the following locations.
From the system chassis to the front door (without a grounding lug):
Remove the rack front door.
1.
Quantity
3
6
6
12
11
1
10
1
1
1
Ground Bonding kit 49
Advertisement
Table of Contents
