Monitoring Power Status; Configuration Examples For Configuring Poe; Budgeting Power: Example; Feature Information For Poe - Cisco Catalyst 2960-XR Configuration Manual

Configuring PoE

Monitoring Power Status

Table 13: Show Commands for Power Status
Command
show env power switch [switch-number]
show power inline [interface-id | module
switch-number]
show power inline consumption
show power inline police

Configuration Examples for Configuring PoE

Budgeting Power: Example

When you enter one of the following commands,
• [no] power inline consumption default wattage global configuration command
• [no] power inline consumption wattage
this caution message appears:
%CAUTION: Interface Gi1/0/1: Misconfiguring the 'power inline
command may cause damage to the
switch and void your warranty. Take precaution not to oversubscribe the power supply. It
is recommended to enable power
policing if the switch supports it. Refer to documentation.

Feature Information for PoE

Release
Cisco IOS 15.0(2)EX1
OL-29420-01
interface configuration command
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1

Monitoring Power Status

Purpose
(Optional) Displays the status of the internal power
supplies for each switch in the stack or for the
specified switch. The range is 1 to 8, depending on
the switch member numbers in the stack.
These keywords are available only on
stacking-capable switches.
Displays PoE status for a switch or switch stack, for
an interface, or for a specific switch in the stack.
Displays the power consumption data.
Displays the power policing data.
consumption/allocation'
Modification
This feature was introduced.
95