Budgeting Power To A Specific Poe Port; Budgeting Power For Devices Connected To A Poe Port - Cisco Catalyst 2960-XR Configuration Manual

Configuring PoE
Command or Action
Step 2
no cdp run
Example:
Switch(config)# no cdp run
Step 3 power inline consumption default wattage
Example:
Switch(config)# power inline consumption
default 5000
Step 4 end
Example:
Switch(config)# end
Step 5
show power inline consumption default
Example:
Switch# show power inline consumption default

Budgeting Power to a Specific PoE Port

Perform this task to configure the amount of power budgeted to a powered device connected to a specific PoE
port:
SUMMARY STEPS
1. configure terminal
2. no cdp run
3. interface interface-id
4. power inline consumption wattage
5. end
6. show power inline consumption
OL-29420-01
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1

Budgeting Power for Devices Connected to a PoE Port

Purpose
(Optional) Disables CDP.
Configures the power consumption of powered devices
connected to each the PoE port on the switch.
The range for each device is 4000 to 30000 mW (PoE+). The
default is 30000 mW.
Note When you use this command, we recommend you
also enable power policing.
Returns to privileged EXEC mode.
Displays the power consumption status.
91