Configuration Examples For System Mtu; Additional References For System Mtu - Cisco Catalyst 2960-XR Configuration Manual

Configuration Examples for System MTU

Command or Action
Step 7
reload
Example:
Switch# reload
Step 8 show system mtu
Example:
Switch# show system mtu

Configuration Examples for System MTU

This example shows how to set the maximum packet size for a Gigabit Ethernet port to 7500 bytes:
Switch(config)#
Switch(config)# system mtu jumbo 7500
Switch(config)# exit
Switch# reload
If you enter a value that is outside the allowed range for the specific type of interface, the value is not accepted.
This example shows the response when you try to set Gigabit Ethernet interfaces to an out-of-range number:
Switch(config)# system mtu jumbo 25000
% Invalid input detected at '^' marker.

Additional References for System MTU

MIBs
MIB
All supported MIBs for this release.
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
76
Purpose
Reloads the operating system.
Verifies your settings.
^
MIBs Link
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
Configuring System MTU
OL-29420-01