Default Lldp Configuration; Configuration Guidelines - Cisco Catalyst 2960-XR Configuration Manual

Configuring LLDP, LLDP-MED, and Wired Location Service
• IP address
• 802.1X username if applicable
• Device category is specified as a wired station
• State is specified as delete
• Serial number, UDI
• Time in seconds since the switch detected the disassociation
When the switch shuts down, it sends an attachment notification with the state delete and the IP address before
closing the NMSP connection to the MSE. The MSE interprets this notification as disassociation for all the
wired clients associated with the switch.
If you change a location address on the switch, the switch sends an NMSP location notification message that
identifies the affected ports and the changed address information.

Default LLDP Configuration

Table 8: Default LLDP Configuration
Feature
LLDP global state
LLDP holdtime (before discarding)
LLDP timer (packet update frequency)
LLDP reinitialization delay
LLDP tlv-select
LLDP interface state
LLDP receive
LLDP transmit
LLDP med-tlv-select

Configuration Guidelines

• If the interface is configured as a tunnel port, LLDP is automatically disabled.
• If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
OL-29420-01
vlan command on the interface. If the switchport voice vlan vlan-id is already configured on an interface,
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
Default Setting
Disabled
120 seconds
30 seconds
2 seconds
Disabled to send and receive all TLVs
Disabled
Disabled
Disabled
Disabled to send all LLDP-MED TLVs. When LLDP is globally
enabled, LLDP-MED-TLV is also enabled.
Default LLDP Configuration
57