Cisco Catalyst 2960-XR Configuration Manual page 76

Configuring Network-Policy TLV
Command or Action
Step 3
{voice | voice-signaling} vlan [vlan-id {cos
cvalue | dscp dvalue}] | [[dot1p {cos cvalue |
dscp dvalue}] | none | untagged]
Example:
Switch(config-network-policy)# voice vlan
100 cos 4
Step 4
exit
Example:
Switch(config)# exit
Step 5 interface interface-id
Example:
Switch (config)# interface
gigabitethernet2/0/1
Step 6 network-policy profile number
Example:
Switch(config-if)# network-policy 1
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
64
Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Configures the policy attributes:
• voice—Specifies the voice application type.
• voice-signaling—Specifies the voice-signaling application type.
• vlan—Specifies the native VLAN for voice traffic.
• vlan-id—(Optional) Specifies the VLAN for voice traffic. The
range is 1 to 4094.
• cos cvalue—(Optional) Specifies the Layer 2 priority class of
service (CoS) for the configured VLAN. The range is 0 to 7;
the default is 5.
• dscp dvalue—(Optional) Specifies the differentiated services
code point (DSCP) value for the configured VLAN. The range
is 0 to 63; the default is 46.
• dot1p—(Optional) Configures the telephone to use IEEE 802.1p
priority tagging and use VLAN 0 (the native VLAN).
• none—(Optional) Do not instruct the IP telephone about the
voice VLAN. The telephone uses the configuration from the
telephone key pad.
• untagged—(Optional) Configures the telephone to send
untagged voice traffic. This is the default for the telephone.
• untagged—(Optional) Configures the telephone to send
untagged voice traffic. This is the default for the telephone.
Returns to global configuration mode.
Specifies the interface on which you are configuring a network-policy
profile, and enter interface configuration mode.
Specifies the network-policy profile number.
OL-29420-01