How To Configure Lldp, Lldp-Med, And Wired Location Service; Enabling Lldp - Cisco Catalyst 2960-XR Configuration Manual

How to Configure LLDP, LLDP-MED, and Wired Location Service

• You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
• You cannot configure a network-policy profile on a private-VLAN port.
• For wired location to function, you must first enter the ip device tracking global configuration command.

How to Configure LLDP, LLDP-MED, and Wired Location Service

Enabling LLDP

Beginning in privileged EXEC mode, follow these steps to enable LLDP:
SUMMARY STEPS
1. configure terminal
2. lldp run
3. interface interface-id
4. lldp transmit
5. lldp receive
6. end
7. show lldp
8. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 lldp run
Example:
Switch (config)# lldp run
Step 3
interface interface-id
Example:
Switch (config)# interface
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
58
you can apply a network-policy profile on the interface. This way the interface has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Enters global configuration mode.
Enables LLDP globally on the switch.
Specifies the interface on which you are enabling
LLDP, and enter interface configuration mode.
OL-29420-01