Configuring Power Policing - Cisco Catalyst 2960-XR Configuration Manual

Configuring Power Policing

DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
no cdp run
Example:
Switch(config)# no cdp run
Step 3
interface interface-id
Example:
Switch(config)# interface gigabitethernet2/0/1
Step 4 power inline consumption wattage
Example:
Switch(config-if)# power inline consumption
5000
Step 5 end
Example:
Switch(config-if)# end
Step 6
show power inline consumption
Example:
Switch# show power inline consumption
Configuring Power Policing
By default, the switch monitors the real-time power consumption of connected powered devices. You can
configure the switch to police the power usage. By default, policing is disabled.
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
92
Purpose
Enters global configuration mode.
(Optional) Disables CDP.
Specifies the physical port to be configured, and enter
interface configuration mode.
Configures the power consumption of a powered device
connected to a PoE port on the switch.
The range for each device is 4000 to 30000 mW (PoE+).
The default is 30000 mW.
Returns to privileged EXEC mode.
Displays the power consumption data.
Configuring PoE
OL-29420-01