Cisco Catalyst 2960-XR Configuration Manual page 79

Configuring LLDP, LLDP-MED, and Wired Location Service
Command or Action
Step 3
exit
Example:
Switch(config-civic)# exit
Step 4 interface interface-id
Example:
Switch (config)# interface gigabitethernet2/0/1
Step 5 location {additional-location-information word |
civic-location-id {id | host} | elin-location-id id |
custom-location-id {id | host} | geo-location-id {id |
host} }
Example:
Switch(config-if)# location elin-location-id 1
Step 6
end
Example:
Switch(config-if)# end
Step 7 Use one of the following:
• show location admin-tag string
• show location civic-location identifier id
• show location elin-location identifier id
OL-29420-01
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
Configuring Location TLV and Wired Location Service
Purpose
Returns to global configuration mode.
Specifies the interface on which you are configuring the location
information, and enter interface configuration mode.
Enters location information for an interface:
• additional-location-information—Specifies additional
information for a location or place.
• civic-location-id—Specifies global civic location
information for an interface.
• elin-location-id—Specifies emergency location
information for an interface.
• custom-location-id—Specifies custom location
information for an interface.
• geo-location-id—Specifies geo-spatial location
information for an interface.
• host—Specifies the host location identifier.
• word—Specifies a word or phrase with additional location
information.
• id—Specifies the ID for the civic, ELIN, custom, or geo
location. The ID range is 1 to 4095.
Returns to privileged EXEC mode.
Verifies the configuration.
67