Cisco Catalyst 2960-XR Configuration Manual page 72

Configuring LLDP Characteristics
SUMMARY STEPS
1. configure terminal
2. lldp holdtime seconds
3. lldp reinit delay
4. lldp timer rate
5. lldp tlv-select
6. interface interface-id
7. lldp med-tlv-select
8. end
9. show lldp
10. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 lldp holdtime seconds
Example:
Switch(config)# lldp holdtime 120
Step 3 lldp reinit delay
Example:
Switch(config)# lldp reinit 2
Step 4
lldp timer rate
Example:
Switch(config)# lldp timer 30
Step 5
lldp tlv-select
Example:
Switch(config)# tlv-select
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
60
Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Enters global configuration mode.
(Optional) Specifies the amount of time a receiving device
should hold the information from your device before discarding
it.
The range is 0 to 65535 seconds; the default is 120 seconds.
(Optional) Specifies the delay time in seconds for LLDP to
initialize on an interface.
The range is 2 to 5 seconds; the default is 2 seconds.
(Optional) Sets the sending frequency of LLDP updates in
seconds.
The range is 5 to 65534 seconds; the default is 30 seconds.
(Optional) Specifies the LLDP TLVs to send or receive.
OL-29420-01