Or, push the down arrow key to move to the next item on the configuration menu (IF
output).
6-16 Configure IF output frequency
nd
rd
The function enables you to tap the 2
IF signal (10.7MHz) or the 3
IF signal (455KHz)
from the BNC (marked as 10.7MHz) type connector on the rear panel. The 10.7MHz of the
nd
2
IF signal is to be used with an optional SDU5500 or SDU5600 spectrum display unit for
signal analysis. The bandwidth at 10.7 MHz is +/- 5 MHz from the center frequency (10
MHz total).
6-16-1 Selecting IF output frequency
To engage the priority function, push the FUNC key and then push the 7 key.
Push the down arrow key to move the cursor to "IF out SEL" selection point.
This menu is to select the IF output frequency.
Use the main tuning dial or the right arrow key or the left arrow key to select the desired
IF output frequency.
Push the ENT key to accept data and return to a standard display.
Alternatively, push the ESC key to abort entry.
Or, push the down arrow key to move to the next item on the configuration menu
(Reference Signal).
6-17 Configure reference signal source
63