Tuning Frequency - AOR AR-DV1 Operating Manual

3-5-1 TUNING FREQUENCY

3-5-1-1 ENTERING A FREQUENCY USING THE NUMERIC KEYPAD
While in VFO mode, enter the required frequency using MHz format followed by the [ENT] key.
(Example) Frequency entry of 81.3 MHz
Press the [8] key. Press the [1] key. Press the [.] key. Press the [3] key. Press the [ENT] key.
(Example) Frequency entry of 1.134 MHz (1134 kHz)
Press the [1] key. Press the [.] key. Press the [1] key. Press the [3] key. Press the [4] key. Press the
[ENT] key.
Correcting frequency input
Press the [CLR] key to delete the entry from the right hand side.
3-5-1-2 CHANGING FREQUENCY USING THE MAIN DIAL
In VFO mode, the active VFO frequency may be 'tuned' in by using the tuning dial mounted on the right
side of the front panel. Rotate the dial 'clockwise' to increase the frequency or 'counterclockwise' to
decrease the frequency.
3-5-1-3 CHANGING FREQUENCY USING [UP] KEY OR [DOWN] KEY
The [▼] key and [▲] key provide a convenient way to change the frequency.
The step size at which the frequency is incremented or decremented is the same than when frequency is
changed with the main dial.
Press the [▲] key to tune the receiver upward in the step size selected, and use the [▼] key to tune the
receiver downward in frequency.
3-5-1-4 VFO COPY
In VFO mode, press the [F] key and then the [PASS] key to copy the frequency from one VFO to another.
18