Marker Frequency; Marker Frequency Setup; Marker Frequency / Level Auto Output; Transfer The Marker Frequency To Receive Frequency - AOR AR2300 Operating Manual

6-6 Marker frequency

6-6-1 Marker frequency setup

KF
The entered value may be changed according to the frequency span and
frequency range.
To read: KF<CR>
KFnnnn.nnnnnn –mmm
Response:
6-6-2 Marker frequency/ level auto output
KC
To read: KC<CR>
MKnnnn.nnnnnn –mmm
Response:

6-6-3 Transfer the marker frequency to receive frequency

KG

6-7 Spectrum data output

Output the level data of each frequency on the screen.
GL
(Note: The separator (/<CR><LF>) has 160 lines.
To read: GL<CR>
GL<CR><LF>/<SP><CR><LF>
Response:

6-8 High speed spectrum data output

Output the level data of each frequency on the screen in high speed.
FD
Convert the signal strength data of one horizontal dot into 1 byte character. Then
repeat this step for a total of 160 characters and output these data followed by
the OK response (<SP><CR><LF>).
To convert the output data to a signal strength level, subtract 0x20 (in
hexadecimal), then add -100dB.
To read: FD<CR>
FD<SP><CR><LF>
Response:
41
KFnnnn.nnnnnn:
(default: 0082.500000) (MHz)
-mmm: signal level (in dB)
n: 0, 1
KCn
0: Disable data output (default)
1: Enable data output
-mmm: signal level (in dB)
KG
(Direct command)
GL<CR><LF>/<SP><CR><LF>
FD<SP><CR><LF>
nnnn.nnnmmm (MHz)