Table of Contents
Advertisement
VFO
Push this key to select VFO mode. There are 10 VFOs (VFO-A through VFO-J) with the
AR-ONE.
STEP
Push the [FUNC] key, and then push to select the desired frequency step.
MODE
Push this key to select the desired receive mode.
WIDTH
Push the [FUNC] key, and then push this key to select the desired IF band width selection
menu.
ATT
Push this key to activate the RF ATT (Attenuator). Move the cursor to select the desired
parameter. The AUTO selection will work best for most of cases.
AGC
Push this key to select the AGC (Automatic Gain Control) time constant of the receiver.
Move the cursor to select the desired AGC time constant. Usually, FAST is used to receive
CW, MEDIUM for AM and FM, and SLOW for SSB mode. When MANU is selected, any
desired parameter (between 0 – 255) can be selected for manual gain control.
dBm
Push this key to toggle a unit of the incoming signal strength in between dBm, dBuV, or
ordinary S unit.
0 ~ 9 , .
Numeric key
S. SET
Push the [FUNC] key, and then push this key to select the desired memory channels to
scan
in the SELECT SCAN mode.
14
Advertisement
Table of Contents
