Configure Rf-Gain (Radio Frequency Gain) - AOR AR-ONE Operating Manual

The IF gain control reduces the amplification in the receiver's IF circuits and has the effect
of
reducing the sensitivity of the receiver. Normally, this is performed by the AGC system, and
the control is left at maximum gain, but reducing the gain can be useful to limit noise when
listening to CW or SSB signals. The IF gain control is must be used if the AGC is turned off.
The default setting for IF-GAIN is 255, maximum gain control value.
To access the configuration menu, push the FUNC key and then push the 7 key.
Push the down arrow key to move the cursor to "IF-GAIN" selection point.
Use the main tuning dial or the right arrow key or the left arrow key to vary the IF-Gain
level for best reception.
Push the ENT key to accept the data and return to a standard display.
Alternatively, push the ESC key to abort entry.
Or, push the down arrow key to move to the next item on the configuration menu
(RF-GAIN).

6-7 Configure RF-GAIN (Radio Frequency gain)

The RF gain setting switches in the attenuator or preamplifier to suite the band conditions
and antenna in use.
The default setting for RF-GAIN is 255, maximum gain control value.
The value can be adjusted according to the receiving condition.
To access the configuration menu, push the FUNC key and then push the 7 key.
Push the down arrow key to move the cursor to "RF-GAIN" selection point.
Use the main tuning dial or the right arrow key or the left arrow key to vary the RF-Gain
level for best reception.
Push the ENT key to accept the data and return to a standard display.
Alternatively, push the ESC key to abort entry.
53