Configure Delay (Scan Delay And Search Delay) - AOR AR-ONE Operating Manual

Ultra wide band communications receiver

Hide thumbs Also See for AR-ONE:

Table of Contents

To access the configuration menu, push the FUNC key and then push the 7 key.

Push the down arrow key to move the cursor to "RMT-ID" selection point.

Use the main tuning dial or the right arrow key or the left arrow key to change the

AR-ONE's

RS-232C identification address.

Push the ENT key to accept the data and return to a standard display.

Alternatively, push the ESC key to abort entry.

Or, push the down arrow key to move to the next item on the configuration menu

(DELAY).

6-10 Configure DELAY (Scan delay and Search delay)

This parameter affects the time, the AR-ONE will remain on active frequency in scan mode

or search mode once the received signal has disappeared and the squelch has closed.

This

Is particularly useful for customizing how long the receiver will wait for a reply before

resuming scan or search. For example, when communications are passed back and forth

between a control tower / aircraft which may take a few seconds. The limits are OFF /

HOLD

and 0.1 to 0.9 seconds in 0.1 second increments. The default is 2.0 seconds.

To access the configuration menu, push the FUNC key and then push the 7 key.

Push the down arrow key to move the cursor to "DELAY" selection point.

Table of Contents