Power On The Ar-One; Detailed Rs-232C Command Listing Of The Ar-One - AOR AR-ONE Operating Manual

PARITY:
XFLOW:
A multiple command entry is only valid where specified. Where a multiple command entry is
allowed, each command MUST be separated with a space "h20" (HEX DECIMAL). Each
command is completed and a [CR] or [CR][LF]. Although there is no local echo, either [CR]
or specified response should come back from the receiver after confirming the correct
command. If no response has been gained after a short while, the receiver has failed to
receive the command properly. Send a [CR] then re-send the command. Should problem
persist, check your connections and try reducing the RS-232C baud rate.

7-2 Power on the AR-ONE

Connect an RS-232C cable between the AR-ONE and a PC, type any key to power up the
AR-ONE.

7-3 Detailed RS-232C command listing of the AR-ONE

X Power on
QP Power off
^Ann Remote ON
EX Remote off
Remote ID
IDnn
7-3-1 RX MODE
Vx Select VFO
MRmnn Memory mode
MSm Memory scan mode
Memory
SM
mode
SSmm Search mode
NONE
ONE
x: any key to power on the AR-ONE
Power off
Hex value 0x01
Accept a value nn in the range of 00-99 for remote
connection
Remote off
To set: IDnn<CR>
To read:ID<CR>
To set: Vx<CR>
m: 0 – 9 (memory bank)
m: 0 – 9 (memory bank)
select
mm: 01 – 40 (search bank)
nn: 00-99
x:A – J (default :A)
n: 00 – 99 (memory
channel)
(default: 000)
(default: 000)
(default: 01)
65