Audio Recorder Control; Control Relay Status; Control Relay Status Report; Manual Rf Gain - AOR AR5001D Manual

2-14

AUDIO RECORDER CONTROL

2-14-1

CONTROL RELAY STATUS

TP TPn
The relay contact is available at the ACC1 connector to control an external audio
recorder device. When the squelch opens, the relay contact will close.
When squelch closed, then the relay contact will open.
To read: TP<CR>
Response: TPn
2-14-2

CONTROL RELAY STATUS REPORT

TC TCn
When the control relay opens or closes during receive, the relay operation status
will be output by the TP command if the TC command is set to on.
No report will be made if the TC command is set to 0.
To read: TC<CR>
Response: TCn
2-15

MANUAL RF GAIN

This command is available only when the AGC is set to manual mode.
RG RGnnn
To read: RG<CR>
Response: RGnnn
2-16

RF BANDPASS FILTER (FOR BELOW 25 MHz)

HN HNn
This command is to install the Band Pass Filter (BPF) for below 25 MHz.
To read: HN<CR>
Response: HNn
All manuals and user guides at all-guides.com
(n: 0 , 1)
0: Off (Relay contact open) (default)
1: On (relay contact closed)
(n: 0, 1)
0: Off (No report)
1: On (Report by the TP command)
(nnn: 000 ~ 110) (in dB)
(n: 0, 1)
0: Off (No filter)
1: On (Filtered)
(default: 0)
(default: 110)
(default: 0)
21