THE CPL PROTOCOL
SAVE SETUP
Purpose:
To save the current oscilloscope setup in one of 10 internal setup registers. This
setup can be recalled manually or by sending the Recall Setup (RS) command.
The command performs the same as the frontpanel key SETUPS together with
the softkey SAVE. An execution error will be returned if the setup register is write
protected.
Command:
"SS"
pds
<setup reg>
Response:
acknowledge
Example:
100 PRINT #1,"SS";3
110 INPUT#1,ACK
setup reg
represents the setup register number, ranging from 1 ... 10
CR
:'Save setup in reg 3
: Sync on acknowledge
CR
6 - 43
SS