Auto Setup - Fluke CombiScope PM3370B User Manual

3 - 4

3.4 AUTO SETUP

The best way to start each measurement is by using the AUTOSET key. This
automatically finds and scales all relevant parameters on all channels.
Figure 3.3 Measuring setup
Step 1 Connect the probe as shown in figure 3.3.
NOTE: AUTOSET is programmable. Because you have set the instrument in the
"standard setup" before (see Section 3.2), all programmable features are
set to a predefined condition and the instrument is set in the analog mode.
Programming of AUTOSET is explained in Chapters 4 and 5.
Step 2 Press the AUTOSET key.
The scope flashes the message 'AUTO SETTING...' on the screen. In
a few seconds the front-panel settings are adjusted for an optimized
display of the applied signal in the analog mode.
Step 3 The calibration signal is clearly displayed.
The parameters of the channel and the timebase settings are
displayed at the bottom of the screen.
CH1 200mV
2 3 4
1
MTB 200 s CH1
ST6704
GETTING STARTED
AUTO SET
ST6659
9303