Fluke CombiScope PM3370B User Manual page 243

6 - 26
QUERY MEASUREMENT
Purpose:
To obtain measurement data from an oscilloscope.
If the V (Value) parameter is specified, one measured value will be returned.
If the L (Logging) parameter is specified, an infinite number of measured values
will be returned. Cancelling is possible by sending the ASCII character ESC.
If no V or L parameter is specified, one measured value is returned, preceded by
its type, and concluded by its suffix.
Note: If averaging is on, the values will be averaged over the number of
average counts.
Command:
"QM"
"V" only the numerical value of the measurement result is returned
"L" the numerical values of an infinite number of measurement
results is returned; cancelling is possible by sending ASCII
character ESC (= 27 decimal)
n decimal number, specifying the type of measurement to perform
(see table on next page)
"L"
n "V"
THE CPL PROTOCOL
CR
QM