THE CPL PROTOCOL
AUTOSET
Purpose:
To start the AUTOSET function. With this command the oscilloscope will select
the optimum settings (volts, time base, trigger mode, etc.) for the connected
signal(s).
The AutoSet (AS) command performs the same function as pressing the front
panel AUTOSET button.
Command:
"AS"
Response:
acknowledge
Note:
The <acknowledge> will be sent after the AUTOSET has been fully
completed.
Example:
100 PRINT #1,"AS"
110 GOSUB 1000
CR
CR
:'Send command
:'Sync on acknowledge
6 - 7
AS