Fluke CombiScope PM3370B User Manual page 227

6 - 10
DEFAULT SETUP
Purpose:
Sets the oscilloscope to the default setup conditions.
The Default Setup (DS) command performs the same function as pressing the
TEXT OFF and STATUS/LOCAL buttons simultaneously.
The communication interface parameters will not be changed.
Command:
"DS"
Response:
acknowledge
Note: The <acknowledge> is sent after the completion of the change to the
default setups.
Example:
100 PRINT #1,"DS"
110 GOSUB 1000
CR
CR
:'Send command
:'Sync on acknowledge
THE CPL PROTOCOL
DS