THE CPL PROTOCOL
RESET INSTRUMENT
Purpose:
Resets all of the software of the oscilloscope, including the CPL protocol handler
and all of the input and output buffers.
Oscilloscope settings remain the same. Interface parameters are not changed in
order to keep the communication alive.
When the Reset has been completed the oscilloscope responds with an
<acknowledge>.
There is no frontpanel equivalent for this command.
Command:
"RI"
Response:
acknowledge
Note:
<acknowledge> will be sent after the Reset has been completed
Example:
100 PRINT #1,"RI"
110 GOSUB 1000
CR
CR
:'Send command
:'Sync on acknowledge
6 - 41
RI