Fluke CombiScope PM3370B User Manual page 118

HOW TO USE THE INSTRUMENT
This setup can be saved in memory as follows:
- Turn the TRACK control until memory location 's7' is selected.
- Press the softkey 'save'.
The actual setting of the front is
now stored in memory location
's7'. The indication in front of
memory location number 's7'
changes from an open circle to a
closed circle.
To recall a previously stored setting :
- Press the AUTOSET key.
The signal is displayed again with an amplitude of three divisions and with four
periods.
- Press the SETUPS key.
- Use the TRACK control to select the same front number 's7' as in the
previous example.
- Press the softkey next to 'recall'.
The stored settings are recalled and the trace is displayed in the same way as
when the setup was stored.
A STANDARD FRONT setup can be recalled at any time by pressing the STATUS
and TEXT OFF keys simultaneously.
MTB 500 s
CH1 500mV
FRONTS
s6
s7
T
s8
recall
undo
save
TEXT
CLEAR &
PROTECT
ch1
4 - 73
ST6735
9303