Connecting The Management Port; Connecting To A Fibre Channel Port; Removing And Installing Cables Into Sfp Transceivers - Cisco MDS 9132T Connecting Manual

Connecting the Management Port

Connecting the Management Port
The autosensing 10/100/1000 Mbps Ethernet management ports are located on the left side of the front panel
(labeled MGMT ETH0 and MGMT ETH1), below the console port. MGMT ETH0 is the default Ethernet
management port (interface mgmt0). This port is used for out-of-band management of the Cisco MDS 9132T
switch. It can also be used for upstream data transferring.
Note MGMT ETH1 is disabled and reserved for further use.
Use a modular, RJ-45, straight-through UTP cable (Cisco Catalyst 5000 Switch or Cisco Catalyst 6000 Switch)
to connect the 10/100/1000 Mbps Ethernet management ports to external hubs and switches.

Connecting to a Fibre Channel Port

The Fibre Channel ports are compatible with FC LC-type fiber-optic SFP transceivers and cables (see the

Removing and Installing Cables into SFP Transceivers

SAN or for in-band management. For information about configuring the switch for in-band management, see
the Cisco Fabric Manager Fundamentals Configuration Guide
Guide.
Each transceiver must match the transceiver at the other end of the cable, and the cable must not exceed the
stipulated cable length for reliable communications. SFP transceivers can be ordered either separately or with
the Cisco MDS 9132T switch.
Warning
Class 1 laser product. Statement 1008
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
or view directly with optical instruments. Statement 1051
Note Wear an ESD wrist strap connected to the chassis when handling transceivers. Keep optical connectors covered
when not in use, and do not touch connector ends. The fiber-optic connectors must be free of dust, oil, and
other contaminants.
Removing and Installing Cables into SFP Transceivers
Caution To prevent damage to the fiber-optic cables, do not place more tension on them than the rated limit and do
not bend to a radius of less than one inch (2.5 cm) if there is no tension in the cable, or two inches (5 cm) if
there is tension in the cable.
Connecting the Cisco MDS 9132T Switch
4
Connecting the Cisco MDS 9132T Switch
section). You can use these ports to connect to the
or the Cisco NX-OS Fundamentals Configuration