Furuno RC-1500-1T Operator's Manual page 404

A-14
Message file is too big (partial transmission possible).
Message is entered in sending buffer.
Message Send failed.
Message Send pending
Message Send rejected.
No response from communication unit!
Now Self-testing Terminal. (cannot abort)
Now printing
Now Formatting
OK to delete file?
OK to format FD?
Printer error!!
Request started
SAVING
SES is not idle now. Cannot start PV Test.
Starting Scan Process Press any key to escape.
Update error! Retry again. Press RET to update end.
The size of the file you want to send is
larger than 31,500 bytes. (The file can be
sent, but only the first 32,000 bytes of in-
formation will be received.)
Before a message is transmitted it is sent
to the message queue. This alert informs
you the message has been accepted by the
message queue.
Could no send message because of satel-
lite malfunction, etc.
.All circuits occupied at LES.
This alert appears when the LES rejects a
message because of unpaid subscriber's
fee or other reasons.
This message will appear if the communi-
cation unit is turned off or its interconnec-
tion cable is disconnected or damaged.
Appears during testing of terminal unit.
Appears during printing.
Appears during formatting of floppy disk.
This alert verifies if it is alright to delete a
file.
This alert verifies if it is alright to format
a floppy disk.
The printer is off or malfunctioning.
This message appears when requesting
delivery status of a message.
You will see this message when saving a
file.
This message means you will have to wait
until the communication unit is idle to start
the PV test.
This prompt appears before scanning NCS.
This message appears if the distress alert
message was updated incorrectly.