Furuno RC-1500-1T Operator's Manual page 305

10. Press [Enter] to open the destination type window.
Figure 3-41 Selection window for "destination type"
Telex communication
TELEX:
Facsimile service
FAX:
- to an office facsimile machine
E-mail (electronic mail) Service
E-Mail:
Circuit Switched Data Network-not used.
CSDN:
Packet Switched Data Network
PSDN:
-to an office computer via a data network using X.25
standard.
X400: For future use
DNID: Data Network ID -not used.
Ship-to shore requests for safety service, accessed by us-
SPEC:
ing special 2-digit codes (See Note 2 below.)
When FAX is selected, select "T30 (FAX)" in the "Mo-
Note 1:
dem Type" selection display. For further details, refer to
page 4-2.
Note 2: When SPEC is selected on the Type line, the Country
Code line disappears. Enter two-digit codes on the Sta-
tion ID line. Refer to page 4-18 for further details.
11. Set up according to Destination Type selection. The steps which
follow show how to set up for TELEX (Prefixed).
12. Press [Enter] to close the destination type window.
13. [ ] to advance the cursor to the Prefix Code line for prefixed.
14. Press [Enter] to open the prefix code window.
15. Key in prefix code in two digits.
Note that some services may not be available depending on LES.
TELEX
FAX
E-Mail
CSDN
PSDN
X400
DNID
SPEC
TELEX (Prefixed)
FAX (Prefixed)
PSDN (Prefixed)
X400 (Prefixed)
DNID (Prefixed)
SPEC (Prefixed)
2-23