Furuno RC-1500-1T Operator's Manual page 150

7.9 User CH Menu
The User ch menu allows registration of user Tx and Rx channels, where permitted by the
Authorities. Follow the instructions below to register user channels.
1. Press the [#/SETUP] key, select USER CH and press the [ENT] key to display the User ch
entry menu.
User ch entry
***
!
MODE: TEL
0201. TX: 2111.5
0202. TX: 2222.0
0203. TX: 2333.5
0204. TX: 2444.0
0205. TX: 2555.5
# $
UP DOWN
2. Press to select MODE and press the [ENT] key.
User ch entry
***
!
MODE: TEL
TEL
0201. TX: 2111.5
NBDP
0202. TX: 2222.0
DSC
0203. TX: 2333.5
0204. TX: 2444.0
0205. TX: 2555.5
# $
UP DOWN
3. Select appropriate mode and press the [ENT] key.
4. Press to select CH and press the [ENT] key.
User ch entry
***
!
MODE: NBDP
0201. TX: 2101.5
0202. TX: 2202.0
0203. TX: 2303.5
0204. TX: 2404.0
0205. TX: 2505.5
# $
UP DOWN
7-10
CAUTION
FURUNO will assume no responsibility
for the disturbance caused by the
unlawful or improper setting of user
channels.
**
"
CH: 2-01
RX: 2111.5
RX: 2222.0
RX: 2333.5
RX: 2444.0
RX: 2555.5
**
"
CH: 2-01
RX: 2111.5
RX: 2222.0
RX: 2333.5
RX: 2444.0
RX: 2555.5
256 channels may be registered.
**
"
CH : 2-01
C H : 0 0 0
Band no. setting range is 0-29 and band channel no. range is
RX: 2101.5
01-99.
RX: 2202.0
RX: 2303.5
For DSC, four channels can be registered per band (2, 4, 6
RX: 2404.0
8, 12, 16, 18, 22, 25).
RX: 2505.5
"0" band is for DSC frequencies only, and they are registered
under "OTHER."