Furuno RC-1500-1T Operator's Manual page 299

Setup
Configuration
No AOR (WEST)
ID FREQ
1 044 11080*
2 0
3 0
4 0
5 0
6 0
7 0
8 0
Figure 2-30 NCS channel list
4. Current NCS common channels are marked with an asterisk. These
channels cannot be changed.
5. Place the cursor where there is no data entered.
6. Press [Enter] to open the text window.
7. Enter NCS channel ID number.
8. Press [Enter] to close the text window.
9. With [ / ] advance the cursor to the frequency column.
10. Press [Enter] to open the text window.
11. Enter NCS channel frequency code.
12. Press [Enter] to close the text window.
13. Press [Esc] to open the update window.
Setup
Configuration
AOR (WEST)
No
ID FREQ
1 044 11080*
2 0
3 0
4 0
5 0
6 0
7 0
8 0
Figure 2-31 NCS channel list, update window
14. Press [Enter] to register input.
The ID number range is 45-63 and the frequency code range
Note:
is 8000-14000. Any ID or frequency entered which is out of
those range will display "Input Error: NCS ID" (for in-
valid ID) or "Input Error: Channel No." (For invalid fre-
quency). Clear the error message by pressing the [Esc] key.
Place the cursor at the invalid ID or frequency code. Then,
press the [Enter] key and enter correct ID or frequency.
15. Press [Esc].
NCS Channel List
ENT: set ESC: quit
AOR (EAST) POR
ID FREQ ID FREQ
144 12580* 244 12580*
1 2
1 2
1 2
1 2
1 2
1 2
1 2
NCS Channel List
ENT: set ESC: quit
AOR (EAST) POR
ID FREQ ID FREQ
144 12580* 244 12580*
1 2
1 2
1 2
1 2
1 2
1 2
1 2
IOR
ID FREQ
344 10840*
3
3
3
3
3
3
3
IOR
ID FREQ
344 10840*
3
3
3
Update
3
3
Yes No
3
Yes
3
2-17