Data Reporting And Polling; Data Reporting; Setting A Data Report - Furuno RC-1500-1T Operator's Manual

DATA REPORTING AND POLLING

Data Reporting

This chapter explains data reporting settings and polling reception.
Data reporting provides automatic data transmission at regular (pre-
set) intervals from your ship to your home office. The data are posi-
tion, speed, bearing and other data sent from a navigational equipment
or an interface unit.
The data transmitted from the FELCOM 12 is temporarily stored in a
data reporting file at the LES. When an operator at your home office
accesses the LES, the LES delivers the data to your home office.
Some LESs may deliver it without being accessed.
Data reporting can be initiated by setting a data report on the FELCOM
12 or receiving a polling command from your home office.
FELCOM 12 offers two types of data reporting as follows:
Data report ---------on MES signalling channel
Refer to "Setting a data report" below.
Message report --- on MES message channel
Refer to "Setting a message report" on page 5-4.

Setting a data report

1. Press [F5] to display the Position Reports menu.
Figure 5-1 Position reports menu
5-1