Furuno RC-1500-1T Operator's Manual page 155

8.1 Daily Test
Authorities require that the equipment be checked daily for proper operation to ensure that it will
function properly in the event of distress. Execute the daily test as below.
1. At the DSC standby screen or radiotelephone setting screen, press the [3/TEST] key to start
the test.
2. After several seconds the test results appear followed by the audio alarm. OK denotes
normal operation, and NG (No Good), error. For NG (No Good) contact your dealer for
advice.
DSC-60 daily test
**
JAN-01-2000-15:24
MAIN CPU : OK VER.XX*
MODEM : OK VER.XX*
RCVR1 : OK
RCVR2 : OK
REMOTE RT : OK FS1562
REMOTE DP : OK DP-6
8. CHECKING, MAINTENANCE
WARNING
Do not open the equipment.
Hazardous voltage which can
cause electrical shock exists
inside the equipment. Only
qualified personnel should
work inside the equipment.
MAIN CPU:
**
MODEM:
RCVR1:
RCVR2:
REMOTE RT:
REMOTE DP:
Alarm:
* XX = Version number
ROM/RAM test executed and version no. displayed.
DSP ROM and DSC signal loopback tests executed and
version no. displayed.
Distress/safety watch received tested.
Routine watch receiver (option) tested.
CAID of MIF command sent and received. Name of
equipment connected (if FURUNO make) and result appear.
(System setting RP PORT must be set for RT or MIF otherwise
nothing appears.)
CAID of MIF command sent and received. Name of
equipment connected (if FURUNO make) and result appear.
(Nothing appears when system setting NBDP PORT is OFF.)
Distress alarm sounds for two seconds after completion
of test.
8-1