Furuno RC-1500-1T Operator's Manual page 287

23. Press [Enter] to open the selection window.
Setup
System Date & Time
Preferred NCS
MES Operation Mode
Active Port
Nav Port
Message Output Port
EGC Output Port
9. Configuration
Figure 2-11 System setup menu, message output port
24. Select the DTE where you want to store receive messages.
All receive messages are routed to the main DTE
DTE1:
(connected to DTE1 on the communication unit)
regardless of sub address.
All receive messages are routed to the 2nd DTE
DTE2:
(connected to DTE2 on the communication unit)
regardless of sub address.
All receive messages are routed to the PC/DATA
PC/DATA:
(connected to PC/DATA on the communication unit)
regardless of sub address (not used).
Select to route messages with sub address 000 to
AUTO:
the main DTE, and messages with the sub address
of the 2nd DTE to the 2nd DTE. All other mes-
sages are routed to the main DTE.
Do not select DTE2 or Auto when there is no DTE con-
Note:
nected to the DTE2 port; messages cannot be read from
the communications unit.
25. Press [Enter] to close the selection window.
26. Press [ ] to advance the cursor to the EGC Output Port line.
27. Press [Enter] to open the selection window.
Setup
System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
9. Configuration
Figure 2-12 System setup menu, EGC output port
28. Select the DTE where you want to store receive EGC messages;
DTE1, DTE2 or PC/DATA.
29. Press [Enter] to close the selection window.
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
DTE1
OFF
DTE1
DTE1
DTE2
PC/DATA
AUTO
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
OFF
DTE1
DTE1
DTE1
DTE1+DTE2
2-5